Samsung HT-DB350 - Manual (Page 51)

50
To listen in the auto sound calibration mode, briefly press ASC button.
(If you set the auto sound calibration in the order from 1 to 4 above for the first time)
• The selection alternates between ASC ON and ASC OFF in the display.
• If you select " ASC ON ", you can listen in the auto sound calibration mode and the ASC button will light on the front panel.
If you select " ASC OFF ", you can listen in the mode set in the audio setting of the setup screen.
1 Plug the auto sound calibration
microphone into the auto sound
calibration input jack.
2
Place the auto sound calibration
microphone at the listener's position.
4
5
Press ASC button.
When the message " REMOVE MIC "
appears in the display, unplug the auto
sound calibration microphone.
A bell will sound and
the setup finishes.
• The tone will be output twice, in the given order (L ➝ C ➝ R ➝ RS ➝
LS ➝ SW), and 5.1-channel sound field is optimized automatically.
• The auto sound calibration setup takes about 2 minutes to complete.
3
Adjust the volume control on the main
unit as follows:
• If the distance between the listener and the speaker is over 5 m:
Set the main unit's volume to over 25.
• If the distance between the listener and the speaker is 3 to 5 m:
Set the main unit's volume to 25.
• If the distance between the listener and the speaker is below 3 m:
Set the main unit's volume to 15.
To cancel the auto sound calibration setup, press ASC button.
• The tone output stops, " CANCEL ASC " appears in the display followed by " REMOVE MIC ", and the setup will be cancelled.
A tone is output. A result for each speaker is displayed.
SETUP
31P~68P(DB350/1650)-XSG 2004.9.18 9:33 AM Page 51