Seagate MEDALIST PRO ST36530N/W/WC - Manual (Page 24)

22 Medalist Pro Installation Guide, Rev. B
Initial setup information
The general information beginning on this page applies to all of
the Medalist Pro drive models. After reading the general informa-
tion topics, refer to the appropriate drive-specific section listed
below for additional information about configuring and installing
your particular model.
Drive models Page
ST39140N ST36530N ST34520N 42
ST39140W/LW ST36530W ST34520W/LW 46
ST39140WC/LC ST36530WC ST34520WC/LC 52
General information
The following general information topics are discussed:
• SCSI ID jumpers
• Drive termination
• Terminator power
• Interface drivers and data path width notes
• Other applicable jumper options
• Providing adequate cooling
• Mounting the drive and connecting cables
1
• Formatting the drive
1 This mounting procedure does not apply to “WC” or “LC” model
drives. To mount “WC” or “LC” drives, plug the drive into the
system’s single connector attachment (SCA) position on the
system’s back panel.