Sherwood RD-8601 - Manual (Page 27)

27
• Each time this button is pressed, the corresponding
tone mode is selected and shown for several seconds
as follows:
BASS TRBL(treble) TONE ON
• When the tone mode is off, “TONE OFF” is shown.
Enter the tone mode.
10
• At “TONE ON” mode, you can select “TONE OFF”
mode and vice versa.
TONE ON : When adjusting the tone for your taste.
(“DIRECT” indicator goes off.)
TONE OFF : When listening to a program source
without the tone effect.
(“DIRECT” indicator lights up.)
• In general, we recommend the bass and the treble to
be set to 0(flat) level.
Notes:
• If the tone display disappears, start from the step
again.
• Extreme settings at high volume may damage your
speakers.
• When the digital signals from DTS, Dolby Digital or
MPEG program sources are input or the
EXTERNAL IN is selected as an input source, you
cannot adjust the tone and can hear a program
source without the tone effect.
At the desired tone mode, adjust the tone
as desired.
11
Adjusting the tone(bass and treble)
TONE MODE
ADJUST
ENGLISH