Samsung SRS580DTKG - Manual (Page 28)

3. Remove any residual matter inside the purifier. (Model with the purifier)
1) Open the main water tap to check
whether water is running through the
water tube on the water inlet side of
the purifier.
2) If water does not come out through the
tube, check whether the tap is open.
3) Leave the tap open until clean water is
running out and any residual matter
that built up during manufacturing has
been removed.
INSTALLATION PROCEDURE
1. Connect the water pipe with coupler and tap.
1) Close the main water tap.
2) Connect coupler “A” to the tap.
3) Every join should be protected with sealing tape.
Note:
If the coupler does not fit on the existing
tap, consult the nearest authorised ser-
vice dealer and purchase the right cou-
plers for the installation.
WARRANTY INFORMATION
This water line installation is not covered by the fridge/freezer
or ice maker manufacturer's warranty.
Follow these instructions carefully to minimise the risk of
expensive water damage.
TAP
COUPLER “A”
1) Cut the water tube attached to the purifi-
er to the appropriate length after measur-
ing the distance between the purifier and
the cold water tap.
2) If you wish to reassemble the water inlet
and outlet sides of the purifier during
purifier installation, see the reference
illustration.
2. Select the location where the purifier is to install. (Model with the purifier)
REFERENCE
90DEGREE
SQUARE
The water tube must be connect-
ed to the cold water pipe.
If it is connected to the hot
water pipe, it may cause the purifi-
er to malfunction.
CAUTION
12
COUPLER
WATER INLET SIDE
OF PURIFIER
WATER TUBE
PURIFIER
OUTLET SIDE OF
PURIFIER
WATER TUBE
PURIFIER
OUTLET SIDE OF
PURIFIER
WATER
DA68-00500P 6/26/02 2:35 PM Page 28