Shark SUPER STEAMER SC710 S - Manual (Page 3)

2
WARNING:
This appliance is equipped with a
grounded-type 3-wire cord (3-prong plug). This
plug will only fit into an electrical outlet made for a
3-prong plug. This is a safety feature. If the plug should
fail to fit the outlet, contact an electrician to replace the
obsolete outlet. Do not attempt to defeat the safety
purpose of the grounding pin, part of the 3-prong plug.
ADDITIONAL IMPORTANT SAFEGUARDS cont.
FOR HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS
1. To avoid circuit overload, do not operate another appliance on the same socket (circuit)
2. If an extension cord is absolutely necessary, a 15 ampere 14 gage cord should be used.
Cords rated for less amperage may overheat. Care should be taken to arrange cord so
that it cannot be pulled or tripped over.
3. Do not leave unattended when the system is connected to a power supply/electrical outlet.
CAUTION: This appliance must be unplugged from the electrical outlet
and allowed to cool down before all cleaning and maintenance tasks.
• Let the appliance cool down completely before cleaning or storing.
• Empty all water from the water tank after each use.
• Store in a dry, cool place.
• A periodic rinse of your steam cleaner will free it from deposits. This is
recommended every 10-15 tankfulls to free up any scale deposits. Fill the boiler
with water and shake vigorously. Tilt the cleaner upside down to empty the boiler of
water and any scale deposits.
Cleaning the Nozzles:
Your steamer should not normally require cleaning, however, should you notice a
marked decrease in steam output it may be necessary to remove mineral deposit
build-up from the nozzle orifice. First ensure that there is water in the tank. If tank is
empty, fill with water, (we recommend using purified or demineralized water), then re-
start unit noting whether steam output is normal. If steam output is still low, follow
these cleaning instructions:
1. Unplug steam cleaner from wall outlet.
2. Use a small diameter stiff metal wire such as a straightened metal
paperclip and carefully insert the end of the wire into the nozzle orifice. See
illustration below.
3. Move wire back and forth several times to remove any deposits.
4. Reconnect appliance to power outlet, switch on and note steam output.
5. If steam performance does not improve, repeat steps #1 through #4.
9
USAGE SUGGESTIONS FOR YOUR SUPER STEAMER