Sanyo CLT-D6614 - Manual (Page 12)


GETTING.STARTED
Telephone.line.connection. . . . .
Once the handset battery is fully charged,
connect the telephone line cord to the
THE LINE jack on the back of the base. Plug
the other end into a telephone outlet.
Low.battery.warning
The battery icon indicates the battery status:
FULL. . . . ........EMPTY
1. If the battery power is low, and the phone is in TALK mode, a warning tone
will sound from the handset and ' LOW BATTERY ' will appear on the screen.
2. If the battery is low and the phone is in STANDBY mode, ' LOW BATTERY '
will appear on the screen.
Removing.and.replacing.handset.battery.pack
After years of use, all NiMH rechargeable batteries loose the ability to hold a full
charge and may need to be replaced. The handset uses 1 NiMH 650 mAh 3.6V
(AAA) rechargeable battery pack. Only replace with an approved battery pack
available through SANYO. Contact the SANYO Customer Service Center at
1-800-263-2244 to order.
WARNING:There is a risk of explosion if battery pack is replaced with an
incorrect type. Dispose of used battery pack according to your local waste
management guidelines.
To.install.a.replacement.handset.battery.pack:
1. Remove the battery door cover on the telephone handset.
2. Insert the battery pack according to polarity engraved as shown.
3. Slide the cover back on so that it clicks firmly into place.
-
+
-