Full upgrade – Symantec VERITAS STORAGE FOUNDATION HP-UX User Manual
Page 46
48 Upgrading the product
Upgrading from 4.1 to 5.0
16 Configure SFCFS on system01 and system02. See “
Note: VCS configuration files are not changed during this configuration.
17 Upgrade file systems to proper disk layout version as mentioned in
Upgrading the disk layout versions
18 Verify that all the file systems are working properly and data is intact.
See
cfsmount
(1M).
19 Run
step 7
,
step 9
, and
step 16
on rest of the nodes to be upgraded.
Full upgrade
Following procedure assumes a 4 node cluster system01, system02, system03,
system04 where all nodes are simultaneously upgraded from 4.1 to 5.0.
1
Log in as superuser.
2
Insert the appropriate software disc into your system's DVD drive.
3
Determine the block device file for the DVD drive:
# ioscan -fnC disk
Make a note of the device file as it applies to your system.
4
Create a directory in which to mount the software disc and mount the disc
using the appropriate drive name. For example:
# mkdir -p /dvdrom
# /usr/sbin/mount -F cdfs /dev/dsk/c3t2d0 /dvdrom
5
Change to the top-level directory on the disc:
# cd /dvdrom
6
Install all the prerequisite patches on all the nodes. See “
7
Offline all SFCFS resources on all nodes by running the following
commands on one of the cluster nodes.
# hagrp -offline service_group -sys system01
# hagrp -offline service_group -sys system02
# hagrp -offline service_group -sys system03
# hagrp -offline service_group -sys system04
where service_group is the command that displays the service groups by
hagrp -dep cvm
.