Sharp DK-CL5P - Manual (Page 12)

12
2010 November 3 DK-CL5P_A6 02-27.fm
DK-CL5P
Pr
epa
rat
io
n for Use
Remote control
■ Battery installation
This product contains a CR Coin Lithium Battery which contains
Perchlorate Material – special handling may apply. California
residents, see www.dtsc.ca.gov/hazardouswaste/perchlorate/
Note:
Before using remote control, please remove plastic shield at
battery holder.
1 Whilst pushing the locking tab towards the center of the
remote control, slide out the battery holder.
2 Remove the old battery from the battery holder, insert the
new battery and then slide the battery holder back into the
remote control.
Precautions for battery use:
● Remove the battery if the unit will not be used for long periods
of time. This will prevent potential damage due to battery
leakage.
Caution:
● Do not use rechargeable battery (nickel-cadmium battery,
etc.).
● Danger of explosion if battery is incorrectly replaced.
● Replace only with the same or equivalent type.
● Batteries (battery pack or battery installed) shall not be
exposed to excessive heat such as sunshine, fire or the like.
● Installing the battery incorrectly may cause the unit to
malfunction.
Notes concerning use:
● Replace the battery if the operating distance is reduced or if
the operation becomes erratic. Purchase “CR 2025” 3 V, coin
lithium battery.
● Periodically clean the transmitter on the remote control and
the sensor on the unit with a soft cloth.
● Exposing the sensor on the unit to strong light may interfere
with operation. Change the lighting or the direction of the unit
if this occurs.
● Keep the remote control away from moisture, heat, shock,
and vibrations.
Remote
control
Plastic
shield
Back of remote
control
Battery holder Locking tab
Polarity(+)
symbol
Positive (+)
side up
Locking tab
Battery type
Battery holder