Schumacher Manual Battery Charger SWI-1224 - Manual (Page 42)

• 38 •
Assemble the Wheels and Axle 10.3 : Hold the axle upright on the floor or work surface.
Then, using a hammer, tap one of the axle caps onto the top end of the axle. Be sure
to tap the axle cap on straight. Slide both wheels onto the axle with the recessed hubs
facing out as shown. Install the second axle cap.
Mount the Axle to the Charger 10.4 : Place one end of each bracket into the slot on the
bottom of the charger. Place the axle assembly under each bracket. Attach the brackets
using the two, 10-32 thread cutting screws provided.
NOTE: Be careful not to drop the brackets inside of the charger case.