Applying power to the sonicwall tz 150 wireless – SonicWALL TZ 150 Wireless User Manual
Page 5
Page 4
Applying Power to the
SonicWALL TZ 150 Wireless
1. Plug the power supply into the back of the security appliance
and into an appropriate power outlet.
Warning: Only use a SonicWALL-approved 12V, 1.66A power
supply.
The Power LED on the front panel lights up green when you
plug in the SonicWALL TZ 150 Wireless. The Test LED lights
up and may blink while the appliance performs a series of
diagnostic tests. When the Test LED is no longer lit, the security
appliance is ready for configuration.
If the Test LED remains lit after the SonicWALL TZ 150 Wireless
has booted, disconnect the power to the security appliance for a
few seconds and plug it back in to restart the unit.
Note: For more trouble shooting information, refer to the
SonicOS Standard 3.0 Administrator’s Guide.
2