Sony CDP-CE405 - Manual (Page 12)

Playing CDs
12 EN
Checking the track order
You can check your programme before or after you
start playing.
Press CHECK.
Each time you press this button, the display shows the
track (the disc and track numbers) or the disc (the disc
number and “AL” indication) of each step in the
programmed order. After the last step in the
programme, the display shows “End” and returns to
the original display. If you check the order after you
start playing, the display shows only the remaining
steps.
Changing the track order
You can change your programme before you start
playing.
To
Erase a track
Erase the last track in the
programme
Add tracks to the end of the
programme
Change the whole
programme completely
4
To programme other discs or tracks, do the
following:
To programme
Other discs
Other tracks on the same disc
Other tracks on other discs
5
Press · to start Programme Play.
To cancel Programme Play
Press CONTINUE.
You can create your programme while checking the
disc labels
While the disc tray is open, follow Steps 1 to 5 with
pressing DISC SKIP to check the disc labels. If you close
the disc tray before Step 5, the total playing time appears
in the display after a while.
Note that, if the programmed track number isn’t found
on the disc, that step is automatically erased.
The programme remains even after the Programme
Play ends
When you press ·, you can play the same programme
again.
The programme remains until you erase it or turn off
the player
If you replace discs, the programmed disc and track
numbers remain. So, the player plays only the existing
disc and track numbers. However, the disc and track
numbers that aren’t found in the player or on the disc are
deleted from the programme, and the rest of the
programme is played in the programmed order.
Note
The total playing time doesn’t appear when:
—You have programmed a track whose number exceeds 20.
—The total playing time of the programme exceeds 200
minutes.
Repeat Step(s)
2
3
2 and 3
Press
CHECK until the track you
don’t want appears in the
display, then press CLEAR
CLEAR. Each time you press
the button, the last track will
be cleared.
DISC 1 – 5 to select the disc,
then number buttons of the
tracks to be added
CLEAR until “ALL CLr”
appears in the display.
Create a new programme
following the programming
procedure.