Troubleshooting, Specifications, Additional information – Sony CDP-CE405 User Manual

Page 19

Advertising
background image

Additional Information

Additional Information

19

EN

Additional Information

Troubleshooting

If you experience any of the following difficulties while

using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.

There’s no sound.

/

Check that the player is connected securely.

/

Make sure you operate the amplifier correctly.

/

Adjust the playback level using the PHONE

LEVEL control on the player (CDP-CE505 only)
or LINE OUT LEVEL +/– on the remote.
(except for CDP-CE305 and CDP-C661)

The CD does not play.

/

There’s no CD inside the player (“no DISC”

appears). Insert a CD.

/

Place the CD with the label side up on the disc

tray correctly.

/

Clean the CD (see page 18).

/

Moisture has condensed inside the player.

Remove the disc and leave the player turned on
for about an hour (see page 2).

The remote does not function. (except for CDP-CE305 and

CDP-C661)

/

Remove the obstacles in the path of the remote

and the player.

/

Point the remote at the remote sensor g on the

player.

/

Replace all the batteries in the remote with new

ones if they are weak.

The player functions incorrectly.

/

The microcomputer chips may be operating

incorrectly. Turn the power off, then turn it
back on to reset the player.

Specifications

Compact disc player

Laser

Semiconductor laser (

λ

= 780 nm)

Emission duration: continuous

Laser output

Max 44.6

µ

W*

* This output is the value measured at

a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.

Frequency response

2 Hz to 20 kHz ± 0.5 dB

Signal-to-noise ratio

CDP-CE505: More than 107 dB
CDP-CE405/CE305/C661: More than
102 dB

Dynamic range

More than 98 dB

Harmonic distortion

CDP-CE505: Less than 0.0035%
CDP-CE405/CE305/C661: Less than
0.0045%

Channel separation

More than 100 dB

Output

Jack
type

Phono
jacks

Optical
output
connector

Stereo
phone jack

Maximum
output
level

2 V
(at 50 kilohms)

–18dBm

10 mW

Load

impedance

Over 10 kilohms

Wave length: 660nm

32 ohms

LINE OUT

DIGITAL OUT
(OPTICAL)
(CDP-CE505
only)

PHONES
(CDP-CE505
only)

Where purchased␣

Europe, China, and
Singapore (except for the
CDP-C661 in Singapore)

Canada

Other countries, and the
CDP-C661 in Singapore

Power requirements

220 V – 230 V AC, 50/60 Hz

120 V AC, 60 Hz

110 V – 120 V or 220 V – 240 V AC,
adjustable, 50/60 Hz

General

Power requirements

Power consumption

14 W

Dimensions (approx.)

430

Ч

120

Ч

385 mm

(w/h/d)

(17

Ч

4 3/4

Ч

15 1/4 in.) incl. projecting

parts

Mass (approx.)

5.6 kg (12 lbs 6 oz)

Supplied accessories

Audio cord (2 phono plugs – 2 phono plugs) (1)
Remote commander (remote) (except for CDP-CE305 and
CDP-C661) (1)
Sony SUM-3 (NS) batteries (except for CDP-CE305 and
CDP-C661) (2)

Design and specifications are subject to change without notice.

Advertising
This manual is related to the following products: