Unpacking, Inventory – Southbend 14" Turn-X Toolroom Lathe 14"x 40" sb1039 User Manual
Page 21
For Machines Mfg. Since 5/11
14" TURN-X
®
Toolroom Lathe
-19-
P R E P A R A T I O N
Unpacking
This item was carefully packaged to prevent
damage during transport. If you discover any
damage, please immediately call Customer
Service at (360) 734-1540 for advice. You may
need to file a freight claim, so save the containers
and all packing materials for possible inspection
by the carrier or its agent.
Inventory
Main Inventory 1: (Figure
11
)
Qty
A. Steady Rest Assembly (Installed) .................1
B. 10" Faceplate w/D1-5 Camlock Stud Set ......1
C. 10" 4-Jaw Chuck w/Combo Jaws (SB1227) ..1
D. 3-Jaw Chuck Key ...........................................1
E. 4-Jaw Chuck Key ...........................................1
F. Follow Rest Assembly (Installed) ..................1
Tool Box Inventory: (Figure
12
)
Qty
G. Tool Box ..........................................................1
H. Open End Wrench 22/24mm .........................1
I. Open End Wrench 14/17mm .........................1
J. Open End Wrench 10/12mm .........................1
K. Phillips Screwdriver #2 .................................1
L. Standard Screwdriver #2 ...............................1
M. Hex Wrench 8mm ..........................................1
N. Tapered Spindle Sleeve MT#5-#3 .................1
O. Dead Center MT#3 .........................................1
P. Carbide-Tipped Dead Center MT#3 ..............1
Q. Camlock Key D1-5 .........................................1
R. Tool Post T-Wrench (Clamped on Tool Post) 1
S. Hex Wrench Set 1.5-10mm ............................1
T. Carriage Handwheel Handle .........................1
U. Cross Slide Handwheel Handle .....................1
V. Cast Iron Leveling Pads ................................6
Pre-Installed (Not Shown)
Qty
• 8" 3-Jaw Chuck (SB1309) ..............................1
•
8
1
⁄
4
" Back Plate D1-5 (SB1399) ......................1
Note: Some inventory components may be
shipped inside of the lathe electrical box. These
items MUST be removed before connecting the
lathe to the power source.
Figure 11. Main inventory.
A
B
C
D
E
F
Figure 12. Toolbox inventory.
G
Q
R
S
O
P
N
H
I
J
K
L
M
V
U
T
If you cannot find an item on this list, check
the mounting location on the machine or the
packaging materials. Sometimes parts are
pre-installed for shipping, or they become
hidden by packaging materials.