Senario VS-MAXXTM 20894 - Manual (Page 3)

POWER SOURCE
The main console has two power options:
1. 4 x AA (1.5 volt) batteries (not included).
2. 6 volt AC/DC adaptor (not included).
BATTERY INSTALLATION AND REPLACEMENT
To install batteries:
1. Remove cover on bottom of console by using a small Philips head screwdriver.
2. Install 4 x AA type batteries into the console. Be sure that the positive (+) and negative
(-) ends of the batteries are facing in the correct direction (see image below). For best
results use only fresh, high quality alkaline batteries.
3. Replace the battery cover.
To replace batteries:
1. Remove cover on bottom of console by using a small Philips head screwdriver.
2. Remove exhausted batteries and dispose of them properly.
3. Replace with 4 x new AA type batteries. Be sure that the positive (+) and negative (-)
ends of the batteries are facing in the correct direction (see image below). For best
results use only fresh, high quality alkaline batteries.
4. Replace the battery cover.
Note: When batteries begin to lose their charge, the system will automatically run low power
detection. Thus, a battery symbol will appear on the TV screen to indicate to change the
batteries .