Sharp VL-Z400H-T - Manual (Page 38)

Basic Operations
26
Basic Operations
Camera Recording
Auto Focus
Available modes:
Tape Camera, Card Camera
The camcorder is preset to Auto Focus
mode, which is designed to focus on most
types of subjects. In Auto Focus mode, the
camcorder automatically focuses on the
subject in the centre of the scene. Always
keep the subject in the centre of the scene.
Notes:
• If no subject is in the centre of the scene, the
focus area will expand and the subject
nearest the centre will be focused on.
• Auto Focus may not work in the situations
described on page 54. In these situations,
use the manual focus function.
• The camcorder may not be able to focus
correctly if the subject is closer than
approximately 1.5 m. Set the zoom control to
wide angle, and try refocusing again.
• If the lens is dirty or fogged, the camcorder
may not be able to focus correctly.
Macro Shots
Available modes:
Tape Camera, Card Camera
This camcorder lets you shoot close-up
images of small objects such as flowers and
insects, or make title frames for your videos.
When you want to record a magnified image
of a subject which is within approximately
1.5 m of the camcorder, do not zoom in on
it. Instead, zoom out all the way by pushing
the Power Zoom control to the W side, and
then move the camcorder closer to the
subject until you obtain the desired angle of
view. The camcorder will automatically
focus on the subject when the lens is set for
the widest angle.
Note:
• When you are recording a macro shot, be
sure that the subject receives sufficient
illumination.
3 0 min
T HE
E NDS SOON.
T A P E
T A PE E ND
Warning indicator
Approx. remaining
time
Less than 1 min.
Remaining Recording
Time Display
Available mode:
Tape Camera
When the camcorder is recording in Tape
Camera mode, an on-screen indicator
displays the approximate remaining tape
time in minutes.
The tape has reached
the end.
CHANGE T HE
CAS SE T T E .
T A PE E ND
Remaining
recording time
indicator
Notes:
• The remaining recording time indicator
appears when the on-screen indicators are
turned on.
• The remaining recording time indicator
appears 10 seconds after pressing the
Record Start/Stop button to begin
recording.
• The remaining recording time indicator only
shows the approximate time left. Also, it
varies slightly depending on the length of the
tape used. (This function is based on the
DVM60 tape standard.)
When the remaining recording time reaches
1 minute, a warning indicator will appear.
Prepare a new cassette.
VL-Z400H-022-031 04.3.23, 8:41 AM 26