Source Technologies STI MICR ST9335 - Manual (Page 42)

Secure MICR Printer User’s Guide
©
Source Technologies
July 2003 Page 38 All rights reserved
Print and Purge Audit Report &%SPURGExx$
&%SPURGE Lead in string
x option(s)
$ Command terminator
This command prints and purges the Audit Report. All recorded information is deleted. The
optional field can be any combination of the following letters:
T Total Field 4
O Overlay
S Sort by MICR line
C Communicate - send report to host instead of printing - see additional
information below on SPRINT command
For example, the command &%SPURGES$ sorts the records by the MICR line while the
command &%SPURGESO$ sorts the records by the MICR line and prints an overlay with
the data.
Options can be forced on with these commands but they cannot be forced off. In other
words, if the front panel overlay setting is on, it cannot be forced off by a datastream
command. If the front panel overlay setting is off, however, a datastream command can
activate this feature. This command can only be accessed with a valid password
command.
Print Audit Report &%SPRINTxx$
&%SPRINT Lead in string
x option(s)
$ Command terminator
Prints the Audit Report
The optional field can be any combination of the following letters:
T Total Field 4
O Overlay
S Sort by MICR line
U Unsuccessful report only
C Communicate - send report to host instead of printing
The report sent back to the host begins with SOH (0x01) and ends with EOT (04). Since the
reports can be quite long, they will likely be broken into separate buffers which may be
interspersed with non-audit buffers such as PJL JOB status. Each buffer will begin with an
STX character (0x02) and end with ETX (0x03).
Each record will be terminated with carriage return-line feed (0x0D 0A).
Section 8: Audit Trail Reports