Samsung SNP-1000A - Manual (Page 89)

5.3. Sequence Setting
85
ƒ Memorize: Manual operations for minimum 120 seconds after
executing this function are memorized into the internal memory.
Nevertheless, the memorizing time becomes different depending
on the PTZ operation. OVER mark will finish this function.
Note
If the operation range is limited using ①Pan Limit
and ②Tilt Limit, only the operations within the limited
range are memorized.
Note
Press the OSD key to stop the internal memory to
continue saving.
5.3.6. Auto Run
If there is no controller operation by the user for a certain time, the
sequence operation designated by the user will be executed.
ƒ Mode:
- OFF : Auto Run will be cancelled.
- Preset : Auto Run in the corresponding Preset number
- Swing : Auto Run in the corresponding Swing mode
- Group : Auto Run in the corresponding Group number
- Tour : Auto Run in the corresponding Tour number
- Trace : Auto Run in the corresponding Trace number
- A. Pan : 350° Auto Run in Pan direction
※ Auto Pan Speed: Pan operation in the speed designated by
the user.
※ Tilt Angle: The tilt angle set up by the user is kept.