The Swan Corporation KSEU-3020 - Manual (Page 2)

KITCHEN SINK Model No. KSEU-3020
Step-By-Step Installation Instruction
Model KSEU-3020 20 ؆ x 39-3/8؆
(508mm) x (1000mm)
Tools Required
• Ruler
• Drill
• Caulk
• Saber Saw (if counter top cutout is required)
• Screw Driver
TRACE COMPLETELY
AROUND EDGE OF SINK
DRAW A 1-1/2 ؆ (38mm) RADIUS AT EACH CORNER
5/16 ؆ (8mm)
1. If it is necessary to cut out the counter top, invert sink and
position onto the counter top. Locate sink front to rear and right
to left so that the bowl(s) will not interfere with the cabinets
below. Trace a pencil line around the outside edge of the sink
and remove the sink from the counter top. 2. Measure in 5/16 Љ (8mm) from the initial sink outline and draw
a second line inside the first. Draw a 1-1/2
Љ (38mm) radius at
each corner. This second interior line will be your cutout line.
Check Cutout Line Measurements
Model Width Depth
KSEU-3020 38-3/4 Љ (984mm) 19-3/8 Љ (492mm)
Measure the cutout line or the pre-cut opening to be sure it
conforms to the sizes listed.