Smeg SA301W-5 - Manual (Page 12)

Instructions for the user
14
Cooking start: as well as setting a cooking duration time, the user can
also set the cooking end time (up to 12 hours after the current time). To
set the cooking start/end time, proceed as follows.
-
Set the cooking duration time as described in the previous point.
-
Within 6/7 seconds after the last time the or keys are
pressed, press the key to set the cooking end time. The display
will show the current time with the inside segments indicating the
cooking end time illuminated. Use the and keys to set the
cooking start time.
-
6/7 seconds after the last time a key is pressed, the display will
show the current time and the cooking start and end times, indicated
by the illuminated inside segments. The segments on the display
will be constantly on until the current time is the same as the
cooking start time; as soon as the current time reaches the cooking
start time set, all the inside segments will start to flash, indicating
that the oven has started cooking.
- When the end of the cooking time is reached, the timer will switch
off the oven heating elements, the beeps will start and the numbers
on the dial will flash.
-
To reset the entire program set, keep the central key pressed for
1 or 2 seconds : if cooking has already started the oven will have to
be switched off by hand.
-
The image on the right shows an example of
programming: the current time is 7.06 and cooking
is programmed to start at 8 o'clock and finish at 9.
-
At 8 o'clock, the inside segments between 8 and 9
will start to flash and the hour pointer will remain
still.
Caution: for the oven to start cooking after the programming procedure
just described, the thermostat and function selector must be properly set
on the temperature and function required.
3.2.4
"DEMO" Function
Models with analogue/digital programmer feature a "DEMO" function
which deactivates the heating elements while leaving the other functions
unchanged. To activate it, simply press the , and keys for 3/4
seconds. A confirmation beep will inform the user that the function is
active. To deactivate it, simply repeat the same procedure.