Smeg SA301W-5 - Manual (Page 27)

Instructions for the user
8.2.2 With pins
Open the door completely and insert the pins (supplied) into the holes
from the inside. Close the door to an angle of about 45° and lift it off. To
reassemble, fit the hinges into their grooves, then lower the door into
place and extract the pins.
8.3 Removing the door glazing
They should always be kept thoroughly clean. For easier cleaning, the
door glazing can be fully removed by proceeding as described below.
After opening the door and locking it in place as described in point “8.2
Removing the door”, remove the two panes of glass. They are all
removed in two stages: first extract the pane from the guide "A" (see
detail) by sliding it towards you and lifting it slightly, then also free it from
the guide "B". If the door should close during these operations, simply
relock one of the hinges as described in point “8.2 Removing the door”.
The panes of glass can now be washed separately.
Use absorbent kitchen roll; remove stubborn dirt with a damp sponge
and ordinary detergent.
Warning: before removing the panes of glass, make sure that the door
has been locked in open position as described in point 8.2 Removing
door. This operation might have to be repeated during the removal
process if the door is accidentally freed.
After cleaning reassemble the internal glasses following the given inctructions in
reverse order.
DANGER: do not use the product without glasses: the door surface will overheat
29