Spectra Logic T380 - Manual (Page 19)

Replace or Install a Drive Installing the Drive
April 2013 Drive Installation or Replacement—Spectra T200, T380, T680, T950, and T-Finity Library
19
4. Return to the Feedback Required screen displayed on the user interface
(see
Step 5 on page 10 for a replacement drive, or Step 4 on page 11 for
a new drive) and click OK.
The next step depends on whether you are installing a new drive or
replacing a drive.
 Replacement drive—The library powers on the replacement drive
and begins the process of configuring it.
 New drive—If you installed a new drive, you need to add the new
drive to a partition before it can be used (see Adding the Drive to a
Partition on page 26 ). New drives added to the library display an
orange square icon with a “?”, indicating that the drive is not part of
any partition.
When the configuration is complete, the Drives screen refreshes to
show the status of the newly installed drive.
5. Repeat Step 2 through Step 4 for each additional drive.
Figure 16 The Drives screen after adding a drive.