Spectra Logic T380 - Manual (Page 14)

Replace or Install a Drive Removing the Malfunctioning Drive
April 2013 Drive Installation or Replacement—Spectra T200, T380, T680, T950, and T-Finity Library
14
Removing the Malfunctioning Drive
Note: If you are installing an additional tape drive, skip to
Determining Drive Sled Adaptor Requirements on page 15 .
Follow these steps to remove a drive:
1. Locate the drive, as described in Drive Replacement Preparation on
page 9 .
2. Make sure that the Status LED (see Figure 2 on page 10 ) is blinking
amber, indicating that the drive is powered off.
3. Carefully disconnect any cables from the drive.
Note: Label the cables before you disconnect them so you can
reconnect them to the same locations on the new drive.
4. Unlock the drive by pushing the drive lock inward.
Note: Depending on the type of drive, the drive lock may look
different from the one shown in
Figure 8 .
Figure 8 Releasing the drive lock and removing the drive.
Unlock drive
Remove drive