Sony 4-129-925-11(1) - Manual (Page 41)

41 GB
Ad
dition
al I
n
fo
rm
atio
n
Control for HDMI
If you experience any of the following
difficulties while using the “BRAVIA” Sync,
use this troubleshooting guide to help you
remedy the problem.
The Control for HDMI function does not work.
• Check the HDMI connection (page 13).
• Make sure “CTRL: HDMI” is set to “ON” in
AMP menu.
• Make sure the connected component is
compatible with the Control for HDMI
function.
• Check the Control for HDMI settings on the
connected component. See the operating
instructions supplied of the connected
component.
• If you change the HDMI connection,
connect/disconnect the AC power cord
(mains lead), or there is a power failure,
repeat the procedures of ““BRAVIA” Sync
Features” (page 30).
• The stand may not work correctly if you
select a component that is not compatible
with the Control for HDMI function on the
TV side.
No sound is output from the stand and TV
speaker.
• Check the volume of the stand and the TV.
• Select the input of the stand correctly.
The sound is output from both the stand and
the TV.
• If the Control for HDMI function is set to
off, or the selected component is not
compatible with the Control for HDMI
function, turn off the sound of the stand or
the TV.
The System Power Off function does not work.
• Change the setting of the TV to turn
connected components off automatically
when you turn off the TV. For details, refer
to the operating instructions of the TV.
The stand is turned off when you turn off the
TV.
• When the Control for HDMI function is on,
the System Power Off function is active, and
the stand is turned off when you turn off the
TV.
An image does not appear on the TV.
• Check whether HDMI IN and HDMI OUT
are connected in reverse.
When the stand is in standby mode, there is no
image or sound on the TV.
• When the stand is in standby mode, image
and sound are output from the HDMI
component selected the last time you turned
off the stand. If you are enjoying other
component, play the component and
perform the One-Touch Play operation, or
turn on the stand to select the HDMI
component you want to enjoy.
• Make sure “POWER SAVE” is set to “OFF”
in the AMP menu if you connect
components not compatible with the
“BRAVIA” Sync to the stand (page 34).
OTHER
The remote does not function.
• Point the remote at the remote sensor on
the stand.
• Remove any obstacles in the path between
the remote and the stand.
• Replace both batteries in the remote with
new ones, if they are weak.
• Make sure you select the correct input on the
remote.
The volume turns down when the output
method changes from the TV speaker to the
stand speaker.
• The Volume Limit function is working. For
details, refer to “Using the Volume Limit
function” (page 33).
continued