Shoprider 888WNLM User Manual
Page 13
3/29/2010 13
The Powerchair will not function while the drive
mechanism is disengaged (in freewheel).
Both left and right sides must be in drive mode for power chair
to operate. Otherwise the Powerchair motors will spin, but the
unit will not move, until both freewheel levers are engaged. Unit
will spin in circles if only one side is in drive mode.
*** DO NOT PUT INTO DRIVE MODE WHILE MOTORS ARE
SPINNING ****
The drive/freewheel levers are found toward the rear of the Powerchair
(Fig. 3). The freewheel levers (with yellow end cap) will allow you to
disengage the drive mechanism (When the levers are pulled out away
from the unit) the Powerchair is in freewheel mode. ***NOTE*** the
VR2 will not work in Freewheel mode. When the levers are pushed in
(towards the inside of the unit) the motors are engaged and the
powerchair is in drive mode.
Freewheel lever **NOTE** There is a lever on opposite side
Fig. 3
Sticker indicating
position the brakes are
locked or unlocked.