Troubleshooting, Table 1 – Shoprider 888WNLM User Manual
Page 19
![background image](/manuals/154163/19/background.png)
3/29/2010 19
Troubleshooting
The Self-Help Guide (Table 1) is intended to assist in the location of a
fault that may occur in a certain part of the Powerchair.
If after checking the fault from the table below and the fault is still
showing, do not use the Powerchair. Turn off the power and consult
your provider immediately.
Table 1
BATTERY GAUGE
POSSIBLE FAULT
10 Bars flash
An excessive voltage has been applied to the control
system. This is usually caused by a poor battery
connection.
9 Bars flash
The parking brakes have a bad connection. Check the
parking brake and motor connections.
8 Bars flash
A control system fault is indicated. Make sure that all
connections are secure.
7 Bars flash
A joystick fault is indicated. Make sure that the joystick is in
the center position before switching on the control system.
6 Bars flash
Battery charger connected.
5 Bars flash
Right-hand motor wiring fault.
4 Bars flash
Right-hand motor disconnected.
3 Bars flash
Left-hand motor wiring fault.
2 Bars flash
Left-hand motor disconnected.
1 Bar flashes
Low battery voltage.
Battery/ Charging Troubleshooting
Batteries that may go below a minimum voltage due to neglect will be unable to
be re-charged. The orange light blinking is indicating that the batteries will not
charge due to battery being damaged or aged. No light indicates a faulty or
incomplete connection to be checked or consult your authorized provider.