Sub-Zero ICB424 - Manual (Page 13)

13
E L E C T R I C A L R E Q U I R E M E N T S
A 220-240 V AC, 50/60 Hz, 10 amp circuit
breaker and electrical supply are required. A
separate circuit, servicing only this appliance,
is required.
The power supply cord has a grounding plug,
which must be plugged into a mating ground -
ing-type wall recep tacle. Follow all National
Electrical codes and local codes and ordi-
nances when installing the receptacle. For
location of the electrical supply, refer to
the Installation Specifications illustration on
page 12.
IMPORTANT NOTE: A ground fault circuit
interrupter (GFCI) is not recommended and
may cause interruption of operation.
H O M E A L A R M S Y S T E M
If a home alarm system is to be used, refer to
Other Wiring Connections on page 18. In
addition to operating power, the installer may
also be required to supply a home automation
system lead to the unit. This is for a low-
voltage, low-current signal similar to door and
window sensor signals. Common, normally
open and normally closed contact configura-
tions are provided.
Three 6 mm female spade connectors are
located in the compressor compartment and
are accessible behind the kickplate / grille on
Models ICB427 and ICB427R. A minimum of
914 mm of lead wire should be provided for
each contact, exiting the back wall near the
electrical outlet.
U N PA C K I N G A N D M OV I N G
Uncrate the unit, remove its wood base and
discard the shipping bolts that hold the wood
base to the bottom of the unit. Remove all
packing materials and tape.
IMPORTANT NOTE: Do not discard the
kickplate / grille, anti-tip bracket and hardware.
These items will be needed for the installation.
All roller-assembly wine shelves should be
removed to reduce weight and prevent them
from rolling. To remove, pull the shelf out to
its full extension, gently and evenly lift up on
both sides of the front of the shelf and remove.
Reverse the procedure to reinstall the shelf.
Retract the front leveling legs to allow you to
move the unit more easily during installation.
You will extend the leveling legs when the unit
is in its final position to reduce the possibility
of the unit tipping forward.
Use an appliance dolly to move the Wine
Storage unit. Position the dolly at the side of
the unit to prevent damage to finished
surfaces.
M O D E L S I C B 4 2 7 A N D I C B 4 2 7 R I N S T A L L A T I O N
Before moving the Wine Storage unit into
position, protect any finished flooring
with appropriate materials.
Do not use an extension cord. Electrical
ground is required on this appliance.
M O D E L S
I C B 4 2 7
I C B 4 2 7 R