Soleus Air LX-140 - Manual (Page 6)

6
securely closed.
d) Mount terminal ends of the exhaust hose to the unit.
Figure A. Single hose, Outlet Panel
e)
Insert Filter Outlet Panel Cover (Figure A.) to allow air to flow out panel.
f) Open window or sliding door for approximately 5 inches (130 mm)
g) Adjust the length of the window kit to the same length of the window or the sliding
door. For single hose select the panel with one hole (Figure B.)
Figure B
Use all three panels if necessary. Cut the window piece as needed to fit the length
of your window or sliding door. Make sure the single hole panel is on the main
piece is not covered by other pieces.
g) Place the window kit to the window or sliding door. Close the window or door as
far as it goes.
h) Adjust the length of exhaust hose and affix the window kid adapter onto the hole on
the window kit.
2) Dual Hose installation: (2 exhaust ducts required)
Use this installation for maximum cooling and heating for a room.
a) Pull out of both ends of the exhaust ducts for approximately 6”.
b) Screw clockwise the exhaust ducts with one end to the terminal end and other end
to the window kit adapter.
c) Remove exhaust outlet wall covers from the back of the unit by screwing the covers
counter-clockwise before lifting them up.
d) Mount terminal ends of the exhaust hoses to the unit.