Washing table – Splendide WD802M User Manual

Page 12

Advertising
background image

HOW TO USE YOUR NEW WASHER-DRYER
• Load the drum with clothes as previously described.

Close the door.

• Select a program. See chart below.

• Select drying time (and half heat if required).

• Select desired spin speed (high spin only occurs in

regular wash cycle).

• Put the detergent, bleach and fabric conditioner into

the dispenser.

• Press the ON-OFF button to start the machine.
Note: Woolen garments should under no circumstances
be tumble dried.

TUMBLE-DRY
If you want to tumble dry a load without washing, rinsing
or spinning, proceed as follows:

Note: The dry weight of the load must not exceed
requirements previously mentioned.
• Make sure that the power cord is plugged in and that

circuit is energized.

• Make sure that the wash timer knob is at an OFF-DRY

position.

• Press the Half Heat button, if you wish to dry at a low

temperature.

• Set the Dryer Timer knob to the drying time you

require.

• Open the door, load the articles to be dried into the

cylinder and close the door.

• Press the ON/OFF button in and the machine will then

start the drying cycle.

• Door may be opened during drying cycle.

TO RINSE, SPIN AND TUMBLE-DRY
It is possible to rinse, spin and tumble-dry articles which
have not been previously washed in the machine. The dry
weight of the load must not exceed load size previously
described.
• Make sure that the power cord is plugged in and that

the circuit is energized.

• Open the hot and cold water taps fully.

• Load the machine with the articles to be rinsed.

• If you wish, put fabric conditioner in the additives

compartment "D" of the Detergent Dispenser.

• Turn the program selector knob to the position marked

"Rinse". Select the desired heat setting. Press the half
heat if you want a low dry temperature. Set the dryer
timer to the desired time.

• Select the desired spin speed. High speed spin only

occurs in the regular cycle.

• Switch the machine on by pressing the ON/OFF

button.

WASHING TABLE

**Compartments may be used with the selections
indicated.
*With the cycle C/C please proceed as follows.
COLD WASH
Add detergent in compartment "A"

PRE-WASH/COLD WASH

Add detergent in compartment "A" and Switch the
machine on.
When the machine starts the pre-wash, open the
detergent dispenser drawer and add further detergent
to compartment “A” for the REGULAR wash cycle.

Page 10

Advertising