Ruger MINI-14 - Manual (Page 27)

screwdriver to push the magazine bottom rearward as you push down on the
spring-loaded bottom retainer. After the magazine bottom has been slid rearward
off the magazine shell, carefully raise the rear end of the bottom retainer so that
its two small lugs can be slid out the rear of the magazine and carefully remove
the bottom retainer.
CAUTION! It is under spring tension from the magazine
spring. The magazine spring and follower may now be removed from the bottom
of the magazine shell, completing its disassembly. After the magazine has been
soaked in solvent to loosen foreign matter, be certain to shake it vigorously (with
the loading opening away from you) to remove solvent or residue from within
the magazine.
Reassembly of the magazine can be accomplished by hooking the magazine
spring into the hole in the magazine follower from the right side. Reinsert this
assembly upwards into the magazine shell. Carefully compress the spring and
slide the bottom retainer on from the rear. Finally, press the bottom retainer
downward and slide the magazine bottom on from the rear.
Figure 15. Exploded view of the
Mini-14 magazine components.
This illustration is included to
show the relationship and names
of the magazine components.
28