Stamina Products fusion 15-4545 - Manual (Page 13)

USING THE FITNESS MONITOR OR METER
Remove the METER(27) from the METER POST(26).
Open the Battery Door on the back of the meter.
The METER(27) operates with four AA batteries (four batteries
included). Refer to the illustration to install or replace the batteries.
Reattach the METER(27) to the METER POST(26). 1.
2.
3.
4.
Do not mix a new battery with an old battery.
Use the same type of battery. Do not mix an alkaline battery with
another type of battery.
Rechargeable batteries are not recommended. 1.
2.
3.
NOTE:
13
HOW TO INSTALL AND REPLACE BATTERIES:
Automatically scans each function of TIME, SPEED, DISTANCE, CALORIES, and HEART
RATE in sequence with change every four seconds. Press and release the MODE button
until "SCAN" appears on the display.
Displays the time from one second up to 99:59 minutes.
Displays the current speed from zero to 999.9 miles per hour.
Displays the distance from zero to 99.99 miles.
Displays calories burned from zero to 999.9 Kcal.
The Calorie Display estimates the average user's calorie consumption based on the speed
and time of the workout. The Calorie Display is not affected by the load adjustment. It
should be used only as a comparison between workouts on this unit.
Displays your heart rate in beats per minute. To display heart rate, select the Heart Rate
Mode and grasp the PULSE SENSORS(41) on the HANDRAILS(6), one in each hand. The
heart symbol "
" will begin flashing when the METER(27) receives your heart rate reading.
Your heart rate will be displayed approximately five (5) seconds after the heart icon is
shown; however, if your hands aren't placed correctly on the PULSE SENSORS(41), you
will not see a heart rate on the display and the meter will cancel the heart rate circuit after
60 seconds. If this occurs, press the MODE button to restart, place your hands back on the
PULSE SENSORS(41) correctly with the palm on the sensors and the heart rate readout
will appear.
FUNCTIONS:
SCAN:
TIME:
SPEED:
DISTANCE:
CALORIES:
HEART RATE:
Pedal movement or push the MODE button.
Automatic shut off after four minutes of
inactivity. POWER OFF :
POWER ON :
MODE BUTTON:
Press to select display functions, include SCAN, TIME, SPEED,
DISTANCE, CALORIES, and HEART RATE.
Press and hold for three seconds to reset all functions to zero.
The meter will shut off automatically after four minutes of inactivity. All function values will
be kept. Push the MODE button and hold it down for three seconds to reset all functions to
zero. NOTE:
OPERATIONAL INSTRUCTIONS
AA Batteries