Stamina Products fusion 15-4545 - Manual (Page 9)

ASSEMBLY INSTRUCTIONS
9
STEP 6
Refer to the inset drawing. Plug the LEFT and RIGHT PULSE SENSOR WIRES(39, 40) into the REAR
EXTENSION WIRE(38) located on the REAR FRAME(3). Push the plugs, only the plugs, back into the
opening in the REAR FRAME(3). Press the SQUARE PLUG(46) into the slot in the back of the REAR
FRAME(3) allowing the LEFT and RIGHT PULSE SENSOR WIRES(39, 40) to feed through the opening
created in the slot below the SQUARE PLUG(46). Please note that the slot is bigger than the SQUARE
PLUG(46) to allow room for the wires.
STEP 7
Attach the SEAT(47) to the SEAT FRAME(5) with ROUND HEAD BOLTS(M6x1x15mm)(61). Attach the
BACK CUSHION(48) to the SEAT FRAME(5) with BUTTON HEAD BOLTS(M8x1.25x40mm)(58).