Samsung NETWORK DIGITAL VIDEO RECORDER - Manual (Page 20)

15
CHAPTER 6
HARD DRIVE INSTALLATION PROCEDURES
1. Hard drive jumpers need to be set properly in order to make DVR function correctly.
2. Instructions below are for second hard drive installation. If you prefer to have only one drive, please
ignore instruction below. Remove DVR top cover by taking out screws from location shown below:
①
.
②
③
④
⑤
⑥
3. Below picture indicates DVR which one without a H.D.D installed.
4. Please refer to the instruction from hard drive manufactory for correct jumper setting on (master
/slave) mode of the hard drive, mounting the hard drive over DVR base by facing IDE interface to
DVR main board. Match screw holes from bottom to bottom of hard drive and the DVR. Turn over
the DVR from top to bottom side and then mounting up the hard drive by using screws from attached
accessory pack as picture below: