Samson EXPIDETION XP25I - Manual (Page 4)

Important Safety Information
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. This apparatus shall not be exposed
to dripping or splashing liquid and
no object filled with liquid, such as
a vase, should be placed on the ap-
paratus.
6. Clean only with a dry cloth.
7. Do not block any of the ventilation
openings. Install in accordance with
the manufacturer's instructions.
8. Do not install near any heat sources
such as radiators, heat registers,
stoves, or other apparatus (including
amplifiers) that produce heat.
9. Only use attachments/accessories
specified by the manufacturer.
10. Unplug this apparatus during light-
ning storms or when not in use for
long periods of time.
11. Do not override the intended pur-
pose of the polarized or grounding-
type plug. A polarized plug has two
blades, with one wider than the
other. A grounding-type plug has
two blades and a third grounding
prong. The wide blade or third prong
is provided for your safety. If the pro-
vided plug does not fit your outlet,
consult an electrician to replace the
obsolete outlet.
12. Protect the power cord from being
walked on or pinched, particularly at
the prongs, convenience receptacles,
and the point where they exit from
the apparatus.
13. Use only with the cart
stand, tripod bracket,
or table specified by
the manufacture, or
sold with the apparatus.
When a cart is used, utilize caution
when moving the cart/apparatus
combination to avoid injury from
tip-over.
14. Refer all servicing to qualified service
personnel. Servicing is required if the
apparatus has been damaged in any
way, such as power-supply cord or
plug breakage, damage due to liquid
or objects falling onto the appara-
tus, exposure to rain or moisture, or
if the apparatus does not operate
normally, or has been dropped.
15. POWER ON/OFF SWITCH: For prod-
ucts with a power switch, the power
switch DOES NOT break the connec-
tion from the mains.
16. MAINS DISCONNECT: The plug
should remain readily operable.
For rack-mount or installation
where plug is not accessible, an
all-pole mains switch with a contact
separation of at least 3mm in each
pole shall be incorporated into the
electrical installation of the rack or
building.
17. FOR UNITS EQUIPPED WITH EXTER-
NALLY ACCESSIBLE FUSE RECEP-
TACLE: Replace fuse with same type
and rating only.
18. MULTIPLE-INPUT VOLTAGE: This
equipment may require the use of a
different line cord, attachment plug,
or both, depending on the available
power source at installation. Connect
this equipment only to the power
source indicated on the equipment
rear panel. To reduce the risk of fire
or electric shock, refer servicing
to qualified service personnel or
equivalent.