Stanley Black & Decker 45SS - Manual (Page 20)

15
30SS, 36SS, 45SS
Rev: 12/21/2011
Operating Instructions
Transmission Control
Your snow blower is equipped with an easily
adjustable transmission control, which can be
adjusted for forward and reverse speed.
There are six forward and two reverse speeds.
To change the speed, pull the handle out to the right
and move the handle to the desired speed.
IMPORTANT! The snow blower belts are adjusted to ensure the augers stop turning within five (5) seconds of
releasing the impeller control lever. If you are making any belt adjustments whatsoever, for your safety and the safety
of others around you, you must ensure the belts are re-adjusted to achieve this design specification.
To Stop Engine
To stop the engine, pull the safety key up until the engine
and augers/impeller stops running. For safety, it is
recommended that you remove the key when not using the
snow blower.
WARNING
WARNING! Do not operate the snow blower
with defective guards, shields, or without the
safety devices securely in place.
Engage Transmission Drive
To engage the transmission drive squeeze the right lever to
the hand grip.
To disengage, let go of the right lever.
Engage Augers/Impeller Control
To engage the augers/impeller drive, squeeze the left
lever to the handgrip.
To disengage release the left lever.
DO NOT shift gears while the
transmission is engaged.
Come to a complete stop and
disengage the transmission
handle before switching
speed or switching from
forward to reverse.
WARNING