Studer Innotec XTH 3000-12 - Manual (Page 17)

Steca Xtender
Installation and Operating Instructions 723.932 Xtender V0.511 Seite 17
5 Energisation of the installation
It is imperative that the closing cap for the connection compartment be installed and
screwed tight before the installation is energised. There are dangerous voltages within
the interior of the connection compartment.
The connection of the Xtender must be carried out in the order given below. Any disassembly
must be carried out in the reverse order.
1. Connecting the battery
Too high or inappropriate a battery voltage may seriously damage the Xtender. For
example, installing a 24 V battery in the Xtender 3000-12.
If the Xtender has been connected the wrong way around by accident (incorrect polarity
of the battery) it is highly likely that the protection fuse inside the equipment may melt
and will have to be replaced. If such is the case, it will be necessary to disconnect all the
connections to the Xtender including the battery. If, after replacing the fuse, the Xtender
proves not to work correctly after reconnecting the battery with the correct polarity, it will
have to be returned to your distributor for repair.
2. Putting the Xtender(s) in operation using the main ON/OFF switch (1). The Xtender is
supplied and is ready for operation. If you require immediate start-up of the inverter when
the battery is energised, the main switch (1) must be in the “ON” position and the
configuration {1111} activated.
3. Connecting the consumers at the output: Activate the output protection device (F) if
existing, and/or press the ON/OFF button (41). The light indicator “AC out” (46) lights up
or flashes (in the event of an absence of consumers).
4. Activating the input circuit breaker(s) If an AC source (generator or network) valid in
frequency and voltage is present at the AC input, the device automatically goes into
transfer and will start to charge the batteries. The consumers at the output are therefore
supplied directly by the power source present at the input.
Your installation is now in operation. If particular configuration or adjustment is required by the
system, it is recommended to carry this out immediately. Adjustments must be made with the
help of the RCC-02/03 remote control. Please refer to the operating instructions for this
accessory.