Studer Innotec XTH 3000-12 - Manual (Page 34)

Steca Xtender
Installation and Operating Instructions 723.932 Xtender V0.511 Seite 34
12 Control and display parts for the Xtender (fig. 4b)
See chapter 7.1 - p. 26.
Pos. Deno
minat
ion Description Comments
41 ON/OF
F
ON/OFF button The ON/OFF button allows the startup or complete
stoppage of the system such as it has been programmed.
When there are several units in the same system, each unit
must be started up or stopped individually using this button.
42 OFF Light indicator for
stoppage of the
unit When the light indicator flashes it indicates the cause of the
stoppage of the unit, its imminent stoppage or the limitation
of its rated power output according to chapter 7.1 - p. 26.
43 ON Light indicator
showing that the
equipment is in
operation
This indicator is glowing continuously when the device is
working. It flashes when the equipment is at a temporary
stop. Note: The equipment will restart automatically when
the conditions that led to the temporary stoppage have gone
away.
44 Charg
e
Light indicator
showing that the
battery is being
charged This indicator is glowing continuously when the charger is in
operation and has not yet reached the absorption phase.
It flashes twice during the absorption phase and once during
the maintenance phase.
If smart boost mode has been activated it is possible that
this indicator will go out temporarily when source backup is
required by users. (See chapter 6.2.7 - p. 21)
45 AC in Light indicator
showing the
presence of
correct and
synchronised
input voltage This indicator is glowing continuously when an alternative
voltage with correct values is present at the AC IN input (13)
of the device and the current limit {1107) set by the user has
not been reached. It flashes when this limit is reached (see
chapter 6.2.6 – p. 21).
46 AC out Light indicator
showing the
presence of a
voltage at the
output This indicator is glowing continuously when an alternative
voltage of 230V is present at the device output. It flashes
when the device is in “load search” mode due to the
absence of users. (See chapter 6.2.2 – p. 18)
13 Type plate elements (fig. 3b)
See also chapter 7.1 - p. 26.
Pos. Denomination Description Comments
31 Model Model
32 Pnom/P30 Rated power output / power for 30 minutes
33 U Battery Rated battery voltage (input area) See chapter 6.2.8 – p.
28
34 U ACin Rated AC input voltage (input area) See chapter 6.2.2 – p.
118
35 I ACin/out Maximum current at input / output See chapter 6.2.7 - p.
21.
36 U ACout Rated output voltage Or according to {1286}
37 I Charge Maximum charger current See chapter 6.2.4 - p.
19
38 SN:xxxxxxxxxx Serial no.
39 IPxx Protection degree according to IEC 60529