Sanyo VPC-FH1EX - Manual (Page 57)

English
36
SE
T
U
P
Turning on the camera when the power save
(sleep) mode is active
In order to preserve battery pack power, the power save (sleep) function will
automatically turn off the camera after about 1 minute of no use during
shooting, or about 5 minutes of no use during playback (factory-preset
setting).
i When the power save mode is active, you can restore the power by any of
the following methods:
h Press the ON/OFF button.
h Press the [
] or [ ] button.
h Open the monitor unit.
h Press the SET button.
h When the MENU button is used to turn on the camera, the screen to
set the operation sounds appears.
i After the power save mode has been active for about 1 hour, the camera
will switch to the standby mode. In this case, you can restore the power by
pressing the ON/OFF button, or by closing and then opening the monitor
unit.
i When the AC adaptor is connected, the power save mode will become
active about 5 minutes after the camera is turned on (factory-preset
setting).
i The user can specify the time elapsed before the power save mode is
activated (page 128).
i When the camera is connected to a computer or printer, the power save
mode becomes active after about 12 hours.