Sony DVDRW DRIVE VGP-DDRW4 - Manual (Page 24)

24
Lens
improper labels. Carefully follow the
instructions of any label printing
software and label products. Use of such
products occurs entirely at the risk of
the user.
• If the edge of the label on the disc is off
the disc surface or the label is not sticky
enough to stay on the disc surface, the
label may stick to the interior of the disc
drive and cause a malfunction of your
drive. Make sure that the label is
properly fixed on the disc surface before
using the disc.
Sony assumes no libility for any
malfunction of your drive or damage to
the media caused by improper labeling.
Please thoroughly read instruction notes
of your label software and label sheets.
• Do not touch the data side of the disc
(opposite the label), and hold the disc as
shown below.
• Do not store discs in locations subject to
high humidity, high temperatures, direct
sunlight, or high levels of dust.
• Take care not to spill any liquid on your
discs.
• Return discs to their cases when not in
use in order to prevent data damage.
• Use an oil-based felt pen when writing
on a disc.
• Do not use a disc with tape, seals, or
paste on it, as the disc may damage the
drive.
Maintenance
Cleaning the cabinet
Wipe the outside of the drive with a soft,
dry cloth. To remove stubborn stains,
moisten the cloth with a mild, neutral
detergent. Do not use solvents, cleaning
alcohol, benzine, or other substances that
may damage the finish.
Cleaning the lens
If you accidentally touch the lens with
dirty fingers or if dust on the lens prevents
the drive from operating properly, clean
the lens.