Samsung SID-452 - Manual (Page 10)

COLOR DOME CAMERA User’s Manual 19 COLOR DOME CAMERA User’s Manual 18
Connection
Connecting to a Monitor
Connect the VIDEO-OUT jack to the VIDEO-IN jack of monitor.
• As the connecting method varies with the instruments, refer to the manual
supplied with the instrument.
• If necessary, you can connect the monitor to the REMOTE jack on the back of
your camera.
• Only connect the cable when the power is turned off.
• Set the 75Ω / Hi-Z selection switch as shown below if you have an intermediate
device.
CCTV Camera
CCTV Camera
Monitor
Intermediate End monitor
Connecting to Power
Connect the adaptor to the power input connector as shown in the figure below.
The recommended adaptor specification for SID-452N/SID-452P is AC24V, 300mA.
•As shown in the table above, voltage decreases as the wire gets longer.
Therefore use of an excessively long adaptor output line for connection to the
camera may affect the performance of the camera.
*Standard voltage for camera operation : DC 12V ± 10%
*There may be some deviation in voltage drop depending on the type of wire and the manufacturer.
Copper wire size (AWG) #24(0.22mm 2 ) #22(0.33mm 2 ) #20(0.52mm 2 ) #18(0.83mm 2 )
Resistance (Ω / m) 0.078 0.050 0.030 0.018
Voltage Drop (V/m) 0.028 0.018 0.011 0.006
• Be sure to connect power only after all the installation is complete.
• Note that AC or DC adaptor is not supplied with camera.
• Use the UL listed, class 2 power transformer of AC 24V adaptor.
• Ground should be connected to the GND terminal.
Notes
When the resistance value of copper wire is at [20°C(68°F)]