Smeg WDI12C - Manual (Page 11)

GB
11
4. On the opposite side of the f urniture door either insert closing hook “B” or screw in metal plate “C” into
the upper side opposite the hinges. Then insert the door buffer ”D” into the remaining position opposite
the lower hinge
5. Following this operation the f urniture door will be ready to be f itted onto the washer dryer using the 2
screws “A” supplied.
3.7.4 Adjusting the hinges
If the furniture door needs final adjustment the screws “A” can be slackened and the door lev elled. Once levelled
re-tighten the screws
3.7.5
Recessing the appliance
Push the washing machine into its recess. Turn the f eet to horizontally, lev el the machine if necessary and lock
the counter nut with the relative check nut. To prev ent v ibrations f rom the machine from being transmitted to the
surrounding f urniture, check that the sides and top of the appliance are unable to touch the f urniture itself. There
must be a space of at least 2mm all around. The rear part of the machine must also remain some distance
away from the back wall. If the recessing cav ity is higher than 820mm the opening between the f loor and sides of
the machine (when this is installed at the end of a line of furniture), must be completely closed in compliance with
the relative saf ety prov isions.
The cov ering must make it impossible for users to touch liv e parts of the electrical system and must require tools
in order to be remov ed.
Our company declines all responsibility f or damages caused by f ailuresto comply with these safety provisions.
3.7.6 Fitting
the plinth
The base plinth f or kitchen f urniture must be removable in the area in f ront of the washer dry er to allow access for
routine maintenance of the drain pump if it becomes clogged with buttons, fasteners, or similar objects, and for our
engineers to be able to remove the washer dry er f or service.
Please note: our engineers will not remove plinths that have been f ixed into position by glues or mastics, or where
remov al could cause third-party damage.
If a plinth is fitted directly onto the washer dry er then it must be done so with four screws inserted into the four
pre-set holes
Application of the plinth to the furniture must not involve elimination or modification of the washing
machine plinth. Owing to safety reasons, this may not be removed. It must absolutely remain intact and
fixed to the washing machine.