Smeg WDI12C - Manual (Page 8)

GB
8
3.5 DRAIN CONNECTION
1. Insert the end of the drain hose into a drain pipe hav ing an internal diameter of at least 4 cm and a height
ranging between 50 and 90 cm, or attach it (using the relative curv ed plastic prof ile) to a basin or bath tub.
2. Alway s check that the end of the drain hose is securely attached in order to prevent the repulsive f orce of the
water f rom moving it out of position.
Attention!
• Do not bend or obstruct the hose as this will reduce the f low of water.
• Any extensions to the drain hose must not exceed 1 metre, they must hav e the same internal diameter and
must not be obstructed in any way.
• In no circumstances should the end of the drain hose be submerged in water.
3.6 EL ECTRICAL CONNECTION
Bef ore f itting the plug into the socket, make sure that:
1. Input voltage matches that indicated on the name plate attached to the inner edge of the door.
2. The circuit-breaker, pressure relief v alves, power line and socket are capable of withstanding the maxi-
mum rated power input indicated on the name plate.
3. The socket is compatible with the plug supplied with the machine without the need to f it multiple sockets,
adaptors or extension leads that could cause ov erheating or burning.
If the socket does not correspond to the supplied plug, replace the socket with one of a suitable type.
Attention
• The plug must be accessible after installation.
• The appliance must be earthed. Plug the machine into a socket f itted with an efficient earth connection.
The manufacturer declines all responsibility for damage to persons or property resulting from
failure to earth the appliance or from a defective earth connection. Correct electrical connec-
tions guarantee maximum safety.
• This appliance complies with EEC directive 89/336 of 3.5.89 (modified by EEC directive 92/31) relative to the
elimination of radio interference.
• If the power cord is damaged, only replace it with an original spare part av ailable f rom our service depart-
ment.
• Do not insert/remove the plug from the socket if your hands are wet.
• Remove the plug from the socket by gripping the plug and not the cord.