Symbol Technologies PPT 2800 - Manual (Page 22)

20
P P T 2 8 0 0 S e r i e s
• If you have installed additional applications on your PPT
2800 terminal, remove them to recover memory. Select
Start, then Settings, and select the System tab. Tap Re-
move Programs, select the unused program and tap Re-
move.
Beamed data does not transmit:
• Confirm that the PPT 2800 terminals are 5” apart, and there
is a clear path between the two devices.
• Adjust the room lighting or move to a different location.
When receiving beamed data an out of memory message
appears:
• Your PPT 2800 terminal requires at least twice the amount of
memory available as the data you are receiving. For exam-
ple, if you are receiving a 30K application, you must have at
least 60K free.
Your PPT 2800 unit does not accept scan input:
• Verify that the unit is loaded with a scanning application. See
your System Administrator.
• Be sure the symbol is not defaced.
• Be sure you are within proper scanning range.
• Be sure the terminal is programmed to accept the type of bar
code you are scanning.
• If you are expecting a beep on a good decode and don’t hear
one, check that the application is set to generate a beep on
good decode.
• If the scanner stops emitting a laser beam when you press
the trigger, check your battery level. When the battery is low,
the scanner shuts off before the terminal notifies you of the
low battery condition.
Note: If the scanner is still not reading symbols, contact your
distributor or Symbol Technologies.