Sharp Aquos LC 30HV6U - Manual (Page 48)

48
Useful adjustment settings
Moving the picture on the screen
You can move the picture around on the screen.
RECEIVER
POWER
SET/
ENTER
؀
؁
VOL CH
MUTE
MENU TV/SAT/DVD
FAVORITE CH
DTV/DVD TOP
SOURCE DTV/SAT
DTV/SAT
VCR REC
A B C D
RETURN MENU
POWER
MENU
GUIDE
INPUT VOL ؁ VOL ؀
INFO
FLASHBACK
Press a/b/c/d to move an image on the screen to
the desired position. Press SET/ENTER to return to
the initial image position.
NOTE
• While pressing a/b/c/d, an on-screen image,
“Adjusting Position” displays to the desired position.
• This setting cannot be stored. Once the System shuts
down or enters standby mode, the setting is erased. To
move the picture around the screen again, you must
perform the above procedure again.
• The image position setting using the steps on page 47
can be stored. Select either according to your objectives.
• “TV”, “INPUT1”, “INPUT2”, “INPUT3” and “INPUT4” can
each adjust the image position setting on this page. The
same for view modes.
• An on-screen image from a PC source cannot be moved
around.
• Even when the image fills the screen, its position can be
adjusted with this function.
• Initialize the image position by pressing SET/ENTER.