Smeg Vitroceramic Cooking Hob SE631C - Manual (Page 4)

11
THE INSTALLATION AND FITTING WORK MUST BE
CARRIED OUT BY AN AUTHORISED INSTALLATION
TECHNICIAN ACCORDING TO APPLICABLE REGU-
LATIONS.
To install these hobs, a hole with the dimen-
sions specified in the figure, must be cut out
of the top of the work sur face furniture.
The fixing system for these hobs is designed
for work sur faces of 20, 30 and 40 mm thick.
The underside of any furniture located ver ti-
cally above the hob must be at a minimum dis-
tance of 60 mm.
Once the hob location has been measured,
the sealing strip must be fixed to the undersi-
de of the hob.
Attach the fixing clamps as shown in the figu-
re, screwing them to the holes in the undersi-
de of the hob with the self-tapping screws pro-
vided (ø 4.2 mm).
If the furniture thickness is 30 mm or less, use the
M5 self-tapping screws supplied to hold the hob in
place, inserting them through the holes in the
clamps. The screws will form a thread in these
holes as they are screwed into them. These thre-
ads should be formed before the clamp is atta-
ched to the hob.
The clamps and the sealing strip are included
in the deliver y contents.
Before connecting the hob to the electrical
supply, check that the voltage and frequency
of the supply correspond to those shown on
the rating plate on the base of the hob.
The electrical connection should be carried out
using a single-pole switch or a plug, provided this
is accessible, of a rating suitable for the power of
the hob and with a separation of at least 3mm
between contacts, to ensure that the hob can be
disconnected from the mains in case of emer-
gency or for cleaning.
The supply must include a suitable ear th con-
nection, in compliance with applicable regula-
tions.
If it should be necessar y to replace the flexi-
ble hob mains cable, the new cable should be
Note
Selecting a location
for the hob (see fig. 3)
Installation
GB
Fig. 3
575 maximum
Anchoring of the hob
(see fig. 4)
Self-tapping screw for
for mounting sur faces
20 and 30 mm thick
20/30 mm
40 mm
Fig. 4
Electrical connections