Smeg Vitroceramic Cooking Hob SE631C - Manual (Page 5)

12
GB
replaced by the manufacturer since special
tools are required.
Avoid the mains cable resting against the hob
or oven casing oven if installed in the same
piece of furniture.
Note:
• The adhesives used in the manufacture of the
furniture or for applying decorative laminas or
the sur face layer of the work top must be able
to withstand temperatures of up to 100
0 C.
• When handling the hob prior to installation,
take care to avoid cuts caused by sharp edges
or corners.
• When kitchen furniture or equipment is
being installed above the hob, cover it with a
suitable protective sheet, to protect it against
breakage due to blows or excessive pressure.
• Remember that the glass is not coverd by
the guarantee ir it is knocked or mishand-
led.
• Should the glass surface be broken, discon-
nect the hob from the electrical supply imme-
diately to avoid the risk of electric shock.
• The manufacturer does not accept res-
ponsibility for faults or damage due to inco-
rrect installation.
Technical Data
COMMON CHARACTERISTICS OF ALL
MODELS
The supply voltage and frequency are as indica-
ted on the rating plate.
The protection against risk in case of fire is class
"Y", so these hobs may be installed next to a
wall, as shown in figure 5.
Note: While the hobs are in use, and for
some time after they have been switched
off, there will be hot areas that can cause
burns. Keep children away from the hob.
Important:
Keep the guarantee beside this user
manual since it contains important techni-
cal information.
Technical data
50
50
Fig. 5