Samsung CLP 550 User Manual
Page 251
U
SING
Y
OUR
P
RINTER
ON
A
N
ETWORK
E.7
E
• IPX/SPX: Internet Packet eXchange/Sequenced Packet eXchange
• TCP/IP: Transmission Control Protocol/Internet Protocol
• DLC/LLC: Data Link Control/Logical Link Control
• DHCP: Dynamic Host Configuration Protocol
• BOOTP: Bootstrap Protocol
Printing a Network Configuration Page
The Network Configuration page shows how the network
interface card on your printer is configured. The default settings
which are suitable for most applications are enabled.
1
In ready mode press the Menu button (
) until you see
‘Network’ on the bottom line of the display.
2
Press the Enter button (
) to access the menu.
3
Press the scroll button (
or
) until ‘Print Net CFG’
displays on the bottom line.
4
Press the Enter button (
).
The Network Configuration page prints out.
Setting Network Protocols
When you first install the printer, all supported network
protocols are enabled when you turn the printer on. If a network
protocol is enabled, the printer may actively transmit on the
network even when the protocol is not in use. This may increase
network traffic slightly. To eliminate unnecessary traffic, you can
disable unused protocols.
1
In ready mode press the Menu button (
) until you see
‘Network’ on the bottom line of the display. Press the Enter
button (
) to access the menu.
2
Press the Enter button (
) when ‘Config Network’ displays
on the bottom line.
3
Press the scroll button (
or
) to display ‘Yes’ and press
the Enter button (
). Then press the Upper Level button
(
).
4
Press the scroll button (
or
) until you see the desired
protocol on the bottom line.
You can choose ‘AppleTalk’ or ‘Netware’.
5
Press the Enter button (
).
6
Press the scroll button (
or
) to change the setting to
‘On’ (enable) or ‘Off’ (disable).