Sony SDT-S9000/BM - Manual (Page 13)

12
Interconnections
The SCSI bus allows connection of up to seven peripherals to the host
computer. Use a SCSI cable with a full-pitch connector.
Precautions
• Switch off the host computer and peripherals before connecting the SCSI
cable.
• Make sure the SCSI connectors are pressed tightly together.
• If this unit is the last (or only) device on the SCSI bus, make sure to connect
a SCSI bus terminator to the open connector.
• The total length of the SCSI cable(s) between the host computer and the last
device should be less than 6 meters. *1
SCSI CONNECTOR
AC IN
SCSI ID GND
*1 When using high-speed data transfer with the SDT-S9000/BM, it is recommended that total
length of the SCSI cable not exceed 3m.
Part 2. Preparation
AC power