Sony SDT-S9000/BM - Manual (Page 14)

13
SCSI ID Setting
The SCSI ID is set by the rotary switch on the rear panel. Press the + or -
buttons to move the number up or down, respectively.
As shipped from the factory, the SCSI ID is set to 0. Press the switch buttons,
if necessary, to select the SCSI ID number you require.
Precautions
• The SCSI ID must be different from IDs of the other peripherals on the
SCSI bus.
• As shipped from the factory, SCSI parity is enabled and Term power is ON.
Since the terminating resistor inside the drive is disabled, a SCSI bus
terminator must be connected to the SCSI bus before use.
• Before changing the SCSI ID setting, be sure to turn off the power with the
POWER switch on the front panel.
Configuration Switches Setting *1
Sony SDT-S9000/BM has a set of configuration switches located on its
bottom side. These drives can be made ready to run in major workstations by
setting the configuration switches as shown in the following table.
*1 with the SDT-S9000/BM
Part 2. Preparation