Sherwood RD-7502 - Manual (Page 15)

15
LISTENING TO A PROGRAM SOURCE
Operations
Before operation
• Enter the standby mode.
• The POWER ON/STANDBY button lights up .
This means that the receiver is not
disconnected from the AC mains and a small
amount of current is retained to support the
operation readiness.
• To switch the power off, push the POWER
switch again.
• Then the power is cut off and the POWER ON
/ STANDBY button goes off.
• Each time the "VIDEO" button on the front panel is
pressed, the input source changes as follows:
VIDEO 1 VIDEO 2 VIDEO 3
• Each time the "AUDIO" button on the front panel is
pressed, the input source changes as follows:
CD AUX TAPE
• Each time the BAND button is pressed, the band
changes as follows;
FM ST FM MONO AM XM
When selecting the EXTERNAL IN as desired,
• Depending on the surround back speaker setting, "EXT
IN" is displayed and 8(/7/6) separate analog signals
from the component connected to this input pass
through the tone and volume circuits only and can be
heard from your speakers.
• Press the EXTERNAL IN button or select the desired
input source to cancel the external in function.
• These analog signals can be heard only, not
recorded.
SEL SEL
TONE SOUND PARAMETER
REMOTE CONTROL RC-110
ENTER
VIDEO 1 TAPE VIDEO 2 VIDEO 3
EXT.IN
CD FM/AM/XM AUX
T E S T
ST ER EO
SU RR O U N D SEARCH MODE
EXT.IN
DISPLAY
SEL SEL
CH.LEVEL D/A MODE
SETUP
TONE SOUND PARAMETER
REMOTE CONTROL RC-110
ENTER
VIDEO 1 TAPE VIDEO 2 VIDEO 3
EXT.IN
CD FM/AM/XM AUX
T E S T
ST ER EO
SU RR O U N D SEARCH MODE
VIDEO 1 TAPE VIDEO 2 VIDEO 3
CD FM/AM/XM AUX
Notes:
• Before operating this receiver, first set this unit as desired for optimum performance, doing the system setup procedures. (For
details, refer to “System Setup” on page 34)
POWER ON STANDBY
SLEEP
1
2 3
4
5 6
7
8
0
9
DIMMER
DISPLAY
SEL SEL
P.SCAN
CH.LEVEL
MUTE
D/A MODE
SETUP
ENTER
VOLUME
T E S T
POWER ON STANDBY
• Each time the POWER ON/STANDBY button on the
front panel is pressed, the receiver is turned on to enter
the operating mode or off to enter the standby mode.
• On the remote control, press the POWER ON button to
enter the operating mode or press the STANDBY button
to enter the standby mode.
• In the standby mode, if the INPUT SELECTOR button is
pressed, the receiver is turned on automatically and the
desired input is selected.
1.
In the standby mode, turn the power on.
2.
Switch the speakers on.
3.
Select the desired input source.
• Then the SPEAKER indicator lights up and the sound
can be heard from the speakers connected to the
speaker terminals.
• When using the headphone for private listening, press
the SPEAKER button again to switch the speakers off.
ENGLISH