Sherwood RD-7502 - Manual (Page 24)

ENGLISH
24
7
8
0
9
DISPLAY
SEL SEL
P.SCAN
CH.LEVEL
MUTE
D/A MODE
SETUP
TONE SOUND PARAMETER
ENTER
VOLUME
VIDEO 1 TAPE VIDEO 2 VIDEO 3
EXT.IN
CD FM/AM/XM AUX
T E S T
ST ER EO
SU RR O U N D SEARCH MODE
• Then the memory mode ("CAL" or "REF 1", etc.) is
displayed for several seconds.
• When the memory mode or channel level disappears,
press this button again.
1.
Press the CHANNEL LEVEL button.
2.
Select the desired channel.
3.
Adjust the level of the selected channel as desired.
4.
Repeat the above steps 2 and 3 to adjust each
channel level.
• The LFE level can be adjusted within the range of -10
~ 0 dB and other channel levels within the range of -15
~ +15 dB.
• In general, we recommend the LFE level to be
adjusted to 0 dB. (However, the recommended LFE
level for some early DTS software is -10 dB.) If the
recommended levels seem too high, lower the setting
as necessary.
Adjusting the current channel level
• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit
your tastes.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s memory ("CAL"),
not into preset memory("REF 1", "REF 2").
• Each time these buttons are pressed, the corresponding
channel is selected as follows:
REF 1,2 (or CAL) FL C FR SR
<DTS or DD> SW SL( SB) or( BL BR)
DTS LFE Dolby Digital LFE
( ): Possible depending on whether the surround back channel is
set to "2c" or "1c".
< >: Possible only when the digital signals from Dolby Digital or
DTS program sources that include LFE signal are input.
• Depending on the speaker settings("N”(None or No) and
surround mode, etc., some channels cannot be
selected.
4 5 6
7 8
0
9
DISPLAY
SEL SEL
P.SCAN
CH.LEVEL
MUTE
D/A MODE
SETUP
TONE SOUND PARAMETER
ENTER
VOLUME
VIDEO 1 TAPE VIDEO 2 VIDEO 3
EXT.IN
CD FM/AM/XM AUX
T E S T
ST ER EO
SU RR O U N D SEARCH MODE
CONTROL
POWER ON STANDBY
SLEEP
1
2 3
4 5 6
7
8
0
9
DIMMER
DISPLAY
SEL SEL
P.SCAN
CH.LEVEL
MUTE
D/A MODE
SETUP
ENTER
VOLUME
T E S T
D
CH.LEVEL
CH. LEVEL